Hambrew Links

Close VLF Projects

Close 136 kHz Projects

Close 472 kHz Projects

Close 500 kHz Projects

Close Multiband HF Projects

Close 160m Projects

Close 80m Projects

Close 60m Projects

Close 40m Projects

Close 30m Projects

Close 20m Projects

Close 17m Projects

Close 15m Projects

Close 12m Projects

Close 10m Projects

Close 6m Projects

Close 4m Projects

Close VHF Airband

Close 2m Projects

Close 70cm Projects

Close 23cm Projects

Close 13cm Projects

Close 9cm Projects

Close 6cm Projects

Close 3cm Projects

Close 1,25cm Projects

Close EHF Projects

Close Antenna Matches

Close Shack Accessories

Close Power Supplies

Close Test Equipment

Close µController Arduino

Junk Box Circuits

Close Tubes

Close Transistors 2N-Serie

Close Transistors BC-Serie

Close Transistors BD-Serie

Close Transistors BF-Serie

Close IC 74XX-Serie

Close IC 74LSXX-Serie

Close IC 74SXX-Serie

Close IC LM-Serie

Close IC TDA-Serie

HF Propagation
Visits

   visitors

   visitors online

Search




µController Arduino - CW Projects

Easy build CW decoder based on DSP Goertzel code by OZ1JHM
If you want to build a cw decoder without using other active components than an atmel 328 - Arduino UNO , then this is sure something for you.
http://oz1jhm.dk/content/very-simpel-cw-decoder-easy-build

ICOM Auto Keyer by ON7EQ
Most ICOM transceivers have a voice / message memory on board, able to 'play' 1 ... 4 pre defined messages - very handy to run contests or pile-ups!
https://www.qsl.net/on7eq/projects/arduino_icom_keyer.htm

Morse keyer by PA3HCM
The Arduino prototyping board allows you to build the most advanced and personalized keyer that you have in mind! This article gives you a decent start for such a keyer, by implementing the basic functionality and learn a bit about the Arduino platform if you’re not familiar with this board yet.
http://www.pa3hcm.nl/?p=1010

The K3NG Keyer by OZ1JHM
In the good old days there was a danish keyer called the SQUEEZE KEY. It was almost like yambic B keying but only with one DIT memory. The operators in the Navy and in the army used them, and from one of them, Per OV2V, i learn about this keyer.
http://oz1jhm.dk/content/k3ng-keyer

The TinyKeyer by OK1RR
This keyer, based on Arduino design, employs the famous K3NG code. It can be used with any Windows/Linux/Mac logging or contesting software with Winkeyer USB (K1EL) support.
https://www.ok1rr.com/tinykeyer/tinykeyer.pdf

Zelfbouw CW decoder met LM567 en Arduino door PI4UTR
Deze CW Decoder is een relatief simpel project voor de beginnende zelfbouwer. Je past in één keer analoge techniek, digitale techniek en software toe door het gebruik van een Arduino.
https://a08.veron.nl/zelfbouw/accessoires/cw-decoder/

Zelfbouwproject CW Decoder door PI4KGL
Dit ontwerp is afkomstig van WB3FHC, die ook de software heeft geschreven.
In Electron van april en november 2015 wordt in de rubriek NL-post deze morse decoder beschreven.
https://www.pi4kgl.org/wp/wp-content/uploads/2019/09/MORSE-ZELFBOUWPROJECT.pdf


Creation date : 14/09/2018 @ 23:02
Last update : 24/08/2024 @ 12:13
Category : µController Arduino
Page read 8950 times


Print the article Print the article

Google Ads


^ Top ^