Hambrew Links

Close VLF Projects

Close 136 kHz Projects

Close 472 kHz Projects

Close 500 kHz Projects

Close Multiband HF Projects

Close 160m Projects

Close 80m Projects

Close 60m Projects

Close 40m Projects

Close 30m Projects

Close 20m Projects

Close 17m Projects

Close 15m Projects

Close 12m Projects

Close 10m Projects

Close 6m Projects

Close 4m Projects

Close VHF Airband

Close 2m Projects

Close 70cm Projects

Close 23cm Projects

Close 13cm Projects

Close 9cm Projects

Close 6cm Projects

Close 3cm Projects

Close 1,25cm Projects

Close EHF Projects

Close Antenna Matches

Close Shack Accessories

Close Power Supplies

Close Test Equipment

Close µController Arduino

Junk Box Circuits

Close Tubes

Close Transistors 2N-Serie

Close Transistors BC-Serie

Close Transistors BD-Serie

Close Transistors BF-Serie

Close IC 74XX-Serie

Close IC 74LSXX-Serie

Close IC 74SXX-Serie

Close IC LM-Serie

Close IC TDA-Serie

HF Propagation
Visits

   visitors

   visitors online

Search




Antenna Matches - Dummy Loads

400 Watt Oil-Filled Dummy Load by N4SPP
A dummy load is just one of those standard tools that you need in the shack. It's a load that has a purely resistive impedance of 50 ohms at all frequencies of interest (HF in my case). You don't need to pollute the airwaves while just tuning or testing your transmitter!
https://www.nonstopsystems.com/radio/frank_radio_antenna_dummy.htm

Building A RF Dummy Load by VO1PWF
If your doing any home brewing gear for ham radio its a great idea to have a dummy load. This will to your radio be the perfect antenna...it will never radiate but your radio sees a perfect 50 Ohm impedance.
http://www.linuxwolfpack.com/dummyload-homebrew.php

Dummy load with a 50 Ω stripline (hybrid) resistor. by PAØFRI
Making a dummy load working well into the UHF region is pretty straightforward if one can obtain a 'stripline' or 'hybrid' resistor.
https://pa0fri.home.xs4all.nl/Diversen/Dummyl/dummyloadeng.htm

Oil Filled Dummy Load by AI4JI
This dummy load uses twenty non-inductive resistors in parallel to achieve fifty ohms over a very wide frequency range. The internal components are specially arranged and submerged in oil to dissipate heat and allow extended operation for transmitter tuning, testing and alignments.
https://www.nonstopsystems.com/radio/pdf-ant/antenna-dummy-article-1.pdf

QRP Dummy Load by N5ESE
This is another variation on the "parallel resistor" dummy load. This is one I built during my infatuation with copper pipe. It's perfect for QRP HF operation of 5-watts or less average power, and should be adequate for continuous operation at that level. It's light and compact, about 2-1/2" in length overall.
https://www.nonstopsystems.com/radio/pdf-ant/antenna-dummy-article-3.pdf

QRP Dummy Load and Power Detector by KB9II
Here's a simple but useful accessory for QRP operation: a dummy load - power meter. It presents a good 50-ohm 4-watt load for a transmitter while the rf detector circuit will let you measure the power into it.
http://my.core.com/~jematz/qrp/kb9ii-s3.htm


Creation date : 04/03/2019 @ 21:59
Last update : 18/08/2024 @ 17:39
Category : Antenna Matches
Page read 7912 times

Google Ads


^ Top ^