Hambrew Links

Close VLF Projects

Close 136 kHz Projects

Close 472 kHz Projects

Close 500 kHz Projects

Close Multiband HF Projects

Close 160m Projects

Close 80m Projects

Close 60m Projects

Close 40m Projects

Close 30m Projects

Close 20m Projects

Close 17m Projects

Close 15m Projects

Close 12m Projects

Close 10m Projects

Close 6m Projects

Close 4m Projects

Close VHF Airband

Close 2m Projects

Close 70cm Projects

Close 23cm Projects

Close 13cm Projects

Close 9cm Projects

Close 6cm Projects

Close 3cm Projects

Close 1,25cm Projects

Close EHF Projects

Close Antenna Matches

Close Shack Accessories

Close Power Supplies

Close Test Equipment

Close µController Arduino

Junk Box Circuits

Close Tubes

Close Transistors 2N-Serie

Close Transistors BC-Serie

Close Transistors BD-Serie

Close Transistors BF-Serie

Close IC 74XX-Serie

Close IC 74LSXX-Serie

Close IC 74SXX-Serie

Close IC LM-Serie

Close IC TDA-Serie

HF Propagation
Visits

   visitors

   visitors online

Search




2m Projects - Amplifiers

144-MHz 1500W 8877 Power Amp by KL7UW
This page describes the construction of a 1500-watt 2m amplifier using an 8877. The design follows the classic W6PO design which is described in the Eimac Notes.
http://kl7uw.com/2m-8877.htm

144MHz GS35 Amplifier by EA3AXV
Technical Characteristics: Ouput Power 2KW, Power Gain 13dB, Anode Voltage 4500V, Anode Current 1A, Grid Voltage 42V, Grid Current 300mA, Drive 100W, Harmonic attenuation > 55 dB.
http://www.nd2x.com/EA3AXV-1.html

144MHz GS35b High Power Amplifier by DL4MEA
A presentation of this amplifier and the 70cm twin was hold on the 1998 Weinheim meeting.
http://www.qsl.net/dl4mea/2g35.htm

2 KW Power Amplifier for 144 MHz using the GU84B tetrode by WA6PY
This amplifier is built in home-made aluminum compartment which must be electrically tight in order to avoid RF radiation.
http://www.nd2x.com/gu84-amp.html

20 Watts PA VHF Module by SV1BSX
The MHW 612 by Motorola, is a VHF Broadband power module amplifier for commercial mobile transmitters giving a maximum Output Power of about 20 Watts (50 Ohm).
http://www.qsl.net/sv1bsx/mhw612/mhw612.html

2m Band VHF PA 5 Watts (AB2 Class) by SV1BSX
I have constructed a Homemade VHF Transverter from 28 MHZ to 144 MHZ, but the output Power its only 0,5 Watts, too low for this band, though a QRP-er.
http://www.qsl.net/sv1bsx/5w_vhf/5w_vhf.html

2m Dual Gate FET Low Noise Amplifier by OZ2CPU
My good old FT-290 2m SSB and FM radio, had about 1uV sensitivity before installing this amp.Now it is 150nV just like the best radios I have tested. Stations I could hear with noise, are now loud and clear !!
http://www.webx.dk/oz2cpu/radios/2m-lna.htm

2N6084 144MHz FM Power Amplifier by MØUKD
It uses a 2N6084 RF transistor, and will produce 50w output max. It is a class C amplifier design, and therefore good for FM mode only.
http://m0ukd.com/homebrew/2n6084-144mhz-fm-power-amplifier/

A Dual­Band Power Amplifier by WN2A
It all started with a need to make my mobile FM setup more organized and less haywire. The end result is a neater solution with an auto band-switched unit that gives the amateur radio operator an indication of which band is being transmitted on.
https://www.qsl.net/wn2a/DualBand_PA_RevA.pdf

Amplificatore FM Veicolare 145 MHz da IW2FND
É ormai da tempo che nelle varie fiere del Radioamatore si trovano alcune parti di vecchi apparati telefonici veicolari Italtel, operanti nella banda VHF, che opportunamente smontati permettono di recuperare un amplificatore ibrido di potenza e tanta altra componentistica utile.
http://www.iw2fnd.it/al/sites/default/files/docs/PowerAmpl2m20W.pdf

An 8-Watt, 2-Meter “Brickette” by W7PUA
Put 20 mW into this little amplifier and get a 26-dB increase in transmitted power! Although the amplifier was designed initially for use with the DSP-10 transceiver, any 20-mW-output 2-meter exciter can enjoy the boost!
http://www.arrl.org/files/file/Technology/tis/info/pdf/0006043.pdf

Description of a 144 MHz high power amplifier for 2 x 4CX250B by LAØBY
This page provides information on the design and practical implementation of a rather inexpensive 144 MHz high power amplifier using a pair of ceramic tetrodes, type 4CX250B, in a push-pull configuration. I have used it mainly for MS and EME operation for many years.
http://la0by.darc.de/2m-hpa.htm

Generic VHF PA by SMØVPO
These circuits are my "standard" building blocks that can be used to amplify RF power signals, from 50MHz to 170MHz, just a few component changes are required.
http://sm0vpo.altervista.org/tx/vhfpa-00.htm

Plus de 300 Watts a tube sans bruit refroidi par convection de F6CHT
Cavité 144 refroidissement par convection de la GI7B On aperçoit le link en bérylium.
Le 4ème côté de la cavité est en fait le radiateur.
http://f6cht.free.fr/page2.html

Un ampli 144 avec une GS31B de F6CHT
Un Ampli 144 avec une GS31 (plus de 1500W).
http://f6cht.free.fr/page3.html

VHF Linear Amplifier by SV1BSX
There is not a personal design on this page, just I've transfered useful notes from PHILIPS RF Bipolar Transistors - Data HandBook (1993 Edition), about BLY89C VHF Power transistor, which is very popular among Amateur Radio "homebrewers".
http://www.qsl.net/sv1bsx/BLY89/bly.html


Creation date : 19/08/2007 @ 20:11
Last update : 12/08/2024 @ 09:16
Category : 2m Projects
Page read 76987 times

Google Ads


^ Top ^