Zelfbouw Links

Sluiten 136 kHz Projekten

Sluiten 492 kHz Projekten

Sluiten 500 kHz Projekten

Sluiten Multiband HF Projekten

Sluiten 160m Projekten

Sluiten 80m Projekten

Sluiten 60m Projekten

Sluiten 40m Projekten

Sluiten 30m Projekten

Sluiten 20m Projekten

Sluiten 17m Projekten

Sluiten 15m Projekten

Sluiten 12m Projekten

Sluiten 10m Projekten

Sluiten 6m Projekten

Sluiten 4m Projekten

Sluiten VHF Luchtvaart

Sluiten 2m Projekten

Sluiten 70cm Projekten

Sluiten 23cm Projekten

Sluiten 13cm Projekten

Sluiten 9cm Projekten

Sluiten 3cm Projekten

Sluiten 1,25cm Projekten

Sluiten EHF Projekten

Sluiten Antenne-aanpassingen

Sluiten Shack Accessoires

Sluiten Voedingen

Sluiten Meetinstrumenten

Sluiten µController Arduino

Junk Box Circuits

Sluiten Buizen

Sluiten Transistors BC-Serie

Sluiten Transistors BD-Serie

Sluiten Transistors BF-Serie

Sluiten IC 74XX-Serie

Sluiten IC 74LSXX-Serie

Sluiten IC 74SXX-Serie

Sluiten IC LM-Serie

Sluiten IC TDA-Serie

HF Propagatie
RSS lezer
Bezoekers

   Bezoekers

   Bezoekers online

Waardeer deze Site

The DXZone.com

(10 = hoogste waardering)

Zoeken




136 kHz Projekten - Voorversterkers

136kHz L.F. Pre-amplifier by GØMRF
This circuit is based on a design by Dave Pick G3YXM and was jointly redesigned in 2003 after the original coils and polystyrene capacitors were made obsolete.
http://www.g0mrf.com/preamp.htm
 

137 kHz antenna preamplifier by EA4EOZ
One of the principal problems an amateur operator finds when tries to receive in the 137 kHz band is the really poor performance on typical amateur transceivers.
http://ea4eoz.blogspot.com/2012/09/137-khz-antenna-preamplifier.html

Loop Pre-amp for LF by G3YXM
If you want to use a a small multi-turn loop on LF, you will find that the sensitivity is not good enough to receive the weaker signals. A good preamp for a loop needs to have a high input impedance and good signal handling characteristics (to prevent cross-modulation).
http://www.wireless.org.uk/circuits2.htm#loopamp

Pre-amp/filter for 136kHz by G3YXM
Most modern tranceivers cover LF but the performance is not always very good. All you can hear are strange whistles and burbles which aren't really there! You need this little circuit. It has a gain of about 10dB and a nice sharp band-pass response about 3kHz wide, enough to cover the 136 band.
http://www.wireless.org.uk/circuits2.htm#preamp

Creatie datum : 29/08/2018 @ 01:12
Laatste wijziging : 26/10/2018 @ 21:20
Categorie : 136 kHz Projekten
Pagina gelezen 980 keren

Print deze pagina Print deze pagina

Google Ads
^ Boven ^